Procedure
l Run:
tftp [ -a source-ip-address | -i interface-type interface-number ] tftp-
server [ public-net | vpn-instance vpn-instance-name ] put source-filename
[ destination-filename ]
The router is configured to upload files using TFTP.
----End
8.4.6 Checking the Configuration
When a device is configured as a TFTP client, you can check the source address of the client
and the configured ACL rule.
Prerequisites
Configurations for using the device as a TFTP client are complete.
Procedure
l Run the display tftp-client command to check the device address that is set to the source
address of the TFTP client.
l Run the display acl { name acl-name | acl-number | all } command to check the ACL rule
that is configured on the TFTP client.
----End
Example
Run the display tftp-client command to view the source address of the TFTP client.
<Huawei> display tftp-client
Info: The source address of TFTP client is 1.1.1.1.
Run the display acl{ name acl-name | acl-number | all } to view the ACL rule that is configured
on the TFTP client.
<Huawei> display acl 2001
Basic acl 2001, 2 rules,
Acl's step is 5
rule 5 deny source 10.1.1.10 0
rule 10 permit
8.5 Accessing Files on Another Device Using FTP
This section describes how to configure a router as an FTP client to log in to a FTP server, and
to upload files to or download files from the server.
8.5.1 Establishing the Configuration Task
Before configuring the use of FTP to access files on another device, familiarize yourself with
the applicable environment, complete the pre-configuration tasks, and obtain any data required
for the configuration. This will help you complete the configuration task quickly and correctly.
Huawei AR1200 Series Enterprise Routers
Configuration Guide - Basic Configuration 8 Accessing Another Device
Issue 04 (2012-05-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
157
To Next Page
Loading...
Need help?
General
