The MAC address lists of PCs in the network are saved on the ONT. Configuring MAC filter
rules enables the PCs that conform to the rules to access the Internet service or disables the PCs
that do not conform to the rules to access the Internet service. A PC may have more than one IP
addresses but a unique MAC address. Therefore, configuring MAC filter rules effectively
controls the Internet service access rights of PCs in a LAN.
Table 5-6 describes the parameters related to the MAC filter.
Table 5-6 Parameters related to the MAC address filter
Parameter Description
MAC address filter function Indicates whether to enable the MAC address
filter function by clicking OPEN or
CLOSE.
Filter Mode Indicates the MAC address filter rule of the
blacklist or whitelist.
l Blacklist: indicates that the data meeting
the rule in the filter rule list is not allowed
to pass.
l Whitelist: indicates that the data meeting
the rule in the filter rule list is allowed to
pass.
The filter mode is global config mode. Thus,
the blacklist and whitelist mode cannot be
used at the same time.
Source MAC Address
Indicates the source MAC address in the
MAC address filter rule.
5.5.3 URL Filter Configuration
1. Click the Security tab and then choose URL Filter Configuration from the navigation
tree. In the pane on the right, after enabling URL filter and selecting the filter mode, click
New. On the dialog box that is displayed, configure the URL filter rule for the PC to access
the Internet, as shown in Figure 5-19.
EchoLife HG8010/HG8110/HG8240/HG8245/HG8247/
HG8447 GPON Terminal
Service Manual 5 Web Page Reference
Issue 02 (2011-12-08) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
319
To Next Page
Loading...
Need help?
General
