2. Activate RAID.
For details, see LSI SAS3008IR> Common Tasks (Legacy/Dual Mode) > Activating a
RAID Configuration in Huawei V5 Server RAID Controller Card User Guide.
----End
5.2.3 Installing the Avago SAS3004iMR PCIe RAID Control Card
Procedure
Step 1 Power off the compute node.
For details, see 3.1 Power-Off Procedure.
Step 2 Remove the compute node.
For details, see 3.3 Removing a CH121 V5.
Step 3 Place the compute node on the ESD workstation.
Step 4 Remove the cover.
For details, see 3.5 Removing the Cover.
Step 5 Remove the air duct.
For details, see 3.7 Removing the Air Ducts.
Step 6 Take the spare part out of its ESD bag.
Step 7 Determine the position of the Avago SAS3004iMR RAID controller card.
Step 8 Install the Avago SAS3004iMR RAID controller card.
For details, see 3.12 Installing a PCIe Card.
Step 9 Install the M.2 FRU on the Avago SAS3004iMR RAID controller card.
For details, see 5.2.4 Installing an M.2 FRU on the Avago SAS3004iMR PCIe RAID
Controller Card.
Step 10 Install the air duct.
For details, see 3.8 Installing the Air Duct.
Step 11 Install the cover.
For details, see 3.6 Installing the Cover.
Step 12 Install the compute node.
For details, see 3.4 Installing a CH121 V5.
Step 13 Power on the compute node.
For details, see 3.2 Power-On Procedure.
----End
FusionServer Pro CH121 V5 Compute Node
User Guide
5 Optional Part Installation
Issue 06 (2019-08-10) Copyright © Huawei Technologies Co., Ltd. 97
To Next Page
Loading...
Need help?
General