For details, see MM910 Management Module V100R001 User Guide.
– On the MM910 CLI, run the following command:
powerstate
For details, see MM910 Management Module V100R001 Command Reference.
The following describes how to power on a compute node using the MM910 WebUI.
Procedure
Step 1 Check that the chassis is installed, the power cables are correctly connected, and the PSUs and
fan modules are in position.
Step 2 Log in to the MM910 WebUI.
For details, see 12.3 Logging In to the MM910 WebUI.
Step 3 On the HMM WebUI, choose PSUs&FANs.
The PSUs&Fans page is displayed.
Step 4 Choose PSU Management > Power Control from the navigation tree.
Figure 3-2 Power Control
Step 5 Select the compute node to be powered on, and click Power On.
The selected compute node will be powered on.
NOTE
To power on all compute nodes at a time, select the check box in the header row and click Power On.
----End
3.3 Removing a CH121 V5
Procedure
Step 1 Determine the position of the compute node in the chassis.
FusionServer Pro CH121 V5 Compute Node
User Guide
3 Basic Operations
Issue 06 (2019-08-10) Copyright © Huawei Technologies Co., Ltd. 28
To Next Page
Loading...
Need help?
General