Step 4 Remove the drive.
1. Press the ejector release button on the drive panel to release the ejector lever. See (1) in
Figure 3-22.
2. Open the drive ejector lever completely. See (2) in Figure 3-22.
3. Holding the ejector lever of the drive, pull out the drive for about 3 cm (1.18 in.). Wait
for at least 30 seconds and remove the drive from the server. See (3) in Figure 3-22.
Do not insert or remove drives frequently. If a drive is frequently removed and installed
in an interval shorter than 30 seconds, there are risks that the drive cannot be identified.
Figure 3-22 Removing a drive
Step 5 Place the removed component in an ESD bag.
Step 6 Install a drive filler.
NOTE
Perform this operation only when a drive is not installed immediately.
----End
3.14 Installing a SAS/SATA Drive
l The SATA or SAS drives support hot swap. After a faulty drive is disconnected from its
backplane, wait 30 seconds before removing it. The alarm will not be cleared immediately
after a new drive is installed. It will be cleared after the RAID array rebuild is complete.
Do not frequently hot-swap a drive to prevent new alarms.
l To prevent damage caused by insufficient heat dissipation and high temperature, install
components or filler panels.
FusionServer Pro CH121 V5 Compute Node
User Guide
3 Basic Operations
Issue 06 (2019-08-10) Copyright © Huawei Technologies Co., Ltd. 47
To Next Page
Loading...
Need help?
General