7 WebUI Introduction
7.1 Logging In to the WebUI
Prerequisites
● Operating system: Windows 7 or later
● Browser: Chrome, Firefox, Internet Explorer 9 or later The following uses
Internet Explorer as an example.
Procedure
Step 1 Connect a network cable between the network port on the PC and the FE port on
the smart cooling product.
Step 2 On the home screen, choose Settings > Comm Settings > IP Settings. Change IP
assigning mode to Manual, and set the IP address, subnet mask and default
gateway.
Step 3
Congure the PC IP address and the smart cooling product IP address in the same
network segment.
If the smart cooling product IP address is 192.168.0.10, subnet mask is
255.255.255.0, and default gateway is 192.168.0.1, set the PC IP address to
192.168.0.11, subnet mask to 255.255.255.0, and default gateway to 192.168.0.1.
Step 4 Set LAN parameters.
● If the smart cooling product connects to a LAN and a proxy server has been selected,
perform Step 4.3 and Step 4.4.
● If the smart cooling product connects to the Internet, and the PC in a LAN accesses the
Internet over a proxy server, do not perform Step 4.3 and Step 4.4. Otherwise, you will
fail to access the WebUI.
1. Open the Internet Explorer and choose Tools > Internet Options.
2. Click the Advanced tab and select Use TLS1.1 and Use TLS1.2.
NetCol5000-A050 In-row Air Cooled Smart Cooling
Product
User Manual 7 WebUI Introduction
Issue 08 (2021-09-17) Copyright © Huawei Technologies Co., Ltd. 168
To Next Page
Loading...
Need help?
General
