5486m595.fm Draft Document for Review October 18, 2004
170 IBM Eserver i5 and iSeries System Handbook
intermix I/O towers/units with copper HSL and copper HSL-2 ports. Select the
appropriate cable based on the type of HSL ports to which it is attached, and the
cable length required.
Both the top and bottom enclosures in the #8294 must be connected via SPCN
cables. They must be in an SPCN cable loop. Three SPCN cables are required to
connect both enclosures of the #8294 to the service processor ports of the
system unit. If the top enclosure of the #8294 is attached to a different system
unit, then the top enclosure is connected to the SPCN cable loop of that system
and one or two SPCN cables are required.
Dual line cord capability is required with the bottom enclosure of the #8294. A
#5164 Dual Power Cords - #8294/#9194 is required on the order. Dual line cord
capability is also required on the top enclosure of the #8294, with feature #5165
Dual Power Cords - #8294, if the top enclosure is attached to the same system
unit as the bottom enclosure. If the top enclosure is attached to a different system
unit, then the #5165 is optional. An additional line cord (for a total of four) must be
ordered when a #5165 is installed. Plugging in the second line cord, even if to the
same outlet, enables the AC power modules to be redundant.
#8294 Optional Base 1.8M Rack schematic
A schematic of the #8294 Optional Base 1.8M Rack is shown below.
To Next Page
Loading...
Need help?
General