iSeries I/O adapters and controllers 345
Draft Document for Review October 18, 2004 5486IOA.fm
System unit hardware (PCI)
iSeries PCI IOAs available from IBM are described in this section. IOAs that are
supported but are now
withdrawn from marketing are described in the IBM
Eserver iSeries and AS/400e System Builder, SG24-2155. Withdrawn features
are identified in “Products and features no longer marketed by IBM” on page 840.
Refer to Chapter 22, “Customer Install Features” on page 459, to identify the CIF
status for each supported feature.
#2742 Two-Line WAN IOA
The #2742 Two-Line WAN IOA supports up to two multiple protocol
communications ports when one or two (in any combination) of the following
cables are attached:
#0348 V.24/EIA232 20-ft. (6m) PCI cable
#0349 V.24/EIA232 50-ft. (15m) PCI cable (
withdrawn from marketing 03
December 2002)
#0353 V.35 20-ft. PCI cable
#0354 V.35 50-ft./15m PCI cable (
withdrawn from marketing 03 December
2002)
#0355 V.35 80-ft. PCI cable (withdrawn from marketing July 2000)
#0356 V.36 20-ft. PCI cable
#0358 V.36 150-ft. PCI cable (withdrawn from marketing July 2000)
#0359 X.21 20-ft. PCI cable
#0360 X.21 50-ft./15m PCI cable (
withdrawn from marketing 03 December
2002)
#0365 V.24/EIA232 80-ft. PCI cable (withdrawn from marketing December
2002)
#0367 Operations Console PCI Cable
Multiple #0367 cables may be ordered (but only one per #2742) to serve as
consoles for secondary partitions when Logical Partitioning (#0140) is specified.
When #2742 is selected to support ECS, one of following cables must be
specified: #0348, #0349 or #0365. The #2742 does not support Remote Power
On.
When used as a Direct Attached Adapter for Linux, order the #0613 in place of
the #2742.
To Next Page
Loading...
Need help?
General