5486Up8x.fm Draft Document for Review October 18, 2004
312 IBM Eserver i5 and iSeries System Handbook
With the noticeable exception of System Products Division (SPD) I/O and
migration towers, most I/O supported on OS/400 V5R1 or later on Models
270, 820, 830, or 840 is also supported on Models 520, 550, 570, 595, 800,
810, 825, 870, or 890. Some of the features supported on earlier models
cannot be ordered on new servers, but are supported if they are present.
SPD I/O is not supported by the Eserver i5 models. Customers running on
the 720, 730, 740, 820, 830, and 840 can continue to use their existing SPD
I/O when upgrading to V5R3. Exceptions are noted in “Products and features
no longer marketed by IBM” on page 840, and on the iSeries Upgrade
Planning Web site at:
http://www-1.ibm.com/servers/eserver/iseries/support/planning/
v5r3hardware.html
Most I/O supported on OS/400 V4R1 or later is also supported on Models
820, 830, or 840. SPD I/O is supported when using a migration tower with
Models 820, 830, or 840.
A hardware upgrade to a Model 810, 825, or 870, or to a Model 890 #2497 or
#2498 processor, requires the following code as a minimum:
– February 2003 level of Licensed Internal Code (LIC)
– OS/400 V5R2 Operating System (5722-SS1)
– Cumulative PTF package C3021520 or later
X
SPD I/O
I/O Tower/Drawer Migration
X
X
#5078/#0578 PCI
IXA
#5079/#5074
PCI
#5095/#0595 PCI-X
#5075 PCI
#5294/#5094
PCI-X
#5088/#0588 PCI-X
To Next Page
Loading...
Need help?
General