5486MSum.fm Draft Document for Review October 18, 2004
808 IBM Eserver i5 and iSeries System Handbook
Note 1 CPW is now being used to measure the performance of all iSeries and AS/400e processors. The CPW value
is measured on maximum configurations. The type and number of disk devices, the number of workstation
controllers, the amount of memory, the system model, other factors, and the application being run determine
the performance that is achievable. All iSeries and AS/400e processors announced from September 1996
onward have only CPW performance measurements.
Note 2 This total includes the MFIOP. The combination of internal and external IOPs cannot exceed this number.
Note 3 The maximum combination of 2440, 7208, or 9348 and Tape Libraries may not exceed four.
Note 4 The software group is determined by a combination of processor and interactive feature. The following table
provides a cross reference.
Processor Interactive feature System feature code Software group
#2065 #1506 2A6A P20
#1507 2A6B P30
#1508 2A6C P30
#1509 2A6D P30
#2066 #1506 2A6E P20
#1507 2A6F P30
#1508 2B6A P30
#1509 2B6B P30
#1510 2B6C P30
#2067 #1506 2B6D P30
#1508 2B6E P40
#1509 2B6F P40
#1510 2C6A P40
#1511 2C6B P40
#2068 #1506 2C6C P30
#1508 2C6D P40
#1509 2C6E P40
#1510 2C6F P40
#1511 2D6A P40
Note 5 The system maximum for internal tapes and CD-ROMs is 18.
To Next Page
Need help?
General