Attaching the front brackets to the rear of the device
About this task
Note: In this installation, the brackets are named as listed in the parts list even though the installation of
the brackets is reversed from the flush-front installation.
Complete the following steps to attach the front brackets to the rear of the device.
Procedure
1. Position the right front bracket with the flat side against the right rear side of the device, as shown in
Figure 10 on page 20.
2. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then
into the holes on the side of the device. Use the upper and lower screw holes, leaving the center holes
empty.
3. Repeat step “1” on page 20 and step “2” on page 20 to attach the left rear bracket to the left side of
the device.
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
Figure 10. Attaching the front brackets to the rear of the device
1 - The SAN64B-6 switch
2 - Front brackets
3 - Screws, 8-32 x 5/16-in., flathead Phillips
20
IBM Storage Networking SAN64B-6: SAN64B-6 Installation, Service, and User Guide
To Next Page
Loading...
Need help?
General