IBM SAN64B-6 User Manual

Figure 17. Attaching the front brackets
1 - The SAN64B-6 switch
2 - Front brackets, right and left
3 - Screws, 8-32 x 5/16-in., flathead Phillips
Attaching the front brackets to the rack
About this task
Complete the following steps to install the device in the rack.
Procedure
1. Position the device in the rack, as shown in (Figure 18 on page 29), providing temporary support
under the device until the rack kit is fully secured to the rack.
2. Attach the right front bracket to the right rack upright using two 10-32 x 5/8-in. panhead screws and
two retainer nuts. Use the upper and lower holes in the bracket.
3. Attach the left front bracket to the left rack upright using two 10-32 x 5/8-in. panhead screws and two
retainer nuts.
4. Use the upper and lower holes in the bracket. Tighten all the 10-32 x 5/8-in. screws to a torque of 25
in-lb. (29 cm-kg).
28
IBM Storage Networking SAN64B-6: SAN64B-6 Installation, Service, and User Guide

IBM SAN64B-6 Specifications

General

Brand	IBM
Model	SAN64B-6
Category	Switch
Language	English