6-7
■ Quick split function
When you find a DX station, an important considera-
tion is how to set the split frequency.
When you hold down the
SPLIT
switch for 1 second,
split frequency operation is turned ON and the trans-
mit frequency is equalized to the received frequency.
This shortens the time needed to begin split fre-
quency operation.
The quick split function is ON by default. For your
convenience, it can be turned OFF in Others set
mode. (p. 12-13) In this case, the
SPLIT
switch does
not equalize the transmit frequency to the receive fre-
quency.
q Suppose you are operating at 21.290 MHz (USB)
inVFOmode.
w Hold down
SPLIT
for 1 second.
•SplitfrequencyoperationisturnedON.
•Thetransmitfrequency(unselectedVFO’sreadout)is
equalizedtothereceivefrequency(selectedVFO’srea-
dout).
•“
” indicator appears.
e Enter the desired offset frequency from the keypad
then push
SPLIT
, or set the transmit frequency
with the main dial while pushing [XFC].
•“
” indicator appears when
F-INP
ENT
is pushed.
•Offsetfrequencysettingwiththekeypad—example
To transmit on 1 kHz higher frequency:
- Push
F-INP
ENT
,
1.8
1
then
SPLIT
.
To transmit on 3 kHz lower frequency:
- Push
F-INP
ENT
,
GENE
•
,
7
3
then
SPLIT
.
D Split lock function
The split lock function is convenient for changing only
the transmit frequency. When the split lock function
is not used, accidentally releasing [XFC] while rotat-
ing the main dial, changes the receive frequency. The
split lock function is ON by default, but can be turned
OFF in set mode. (p. 12-13)
q While split frequency operation is ON, push [LOCK]
to activate the split lock function.
w While pushing [XFC], rotate the main dial to
change the transmit frequency.
•Ifyouaccidentallyrelease[XFC]whilerotatingthemain
dial, the receive frequency does NOT change.
Main dial
[SPLIT] indicator
SPLIT
XFC
Main dial
[LOCK] indicator
XFC
LOCK
6
FUNCTIONS FOR TRANSMIT
To Next Page
Loading...
Need help?
General
