4-15
D Functions for the RTTY decoder display
q Push a band key to select the desired band.
w Push
RTTY/PSK
to select RTTY.
•AfterRTTYmodeisselected,holddown
RTTY/PSK
for
1 second to toggle between RTTY and RTTY-R modes.
•“RTTY”or“RTTY-R”appears.
e Push [DECODE]
F-3
to display the decode
screen.
•WhentunedintoanRTTYsignal,decodedcharacters
are displayed in the RX contents screen.
r Push [HOLD/CLR]
F-2
to freeze the current
screen.
•“
HOLD
” appears while the function is in use.
•Push[HOLD/CLR]
F-2
again to release the function.
t Hold down [HOLD/CLR]
F-2
for 1 second to clear
the displayed characters.
•“
HOLD
” indicator disappears at the same time when
the displayed characters are cleared. (The hold func-
tion is cancelled.)
y Push [WIDE]
F-7
to toggle the RTTY decode
screen size between normal and wide.
•S/RFmetertypeduringwidescreendisplaycanbese-
lected in display set mode. (pp. 3-11, 12-10)
u Push
EXIT/SET
to close the RTTY decode screen.
• Wide screen display
D Setting the decoder threshold level
Adjust the RTTY decoder threshold level if some
characters are displayed when no signal is received.
q Select the RTTY decode screen as described
above.
w Push [ADJ]
F-5
to select the threshold level set-
ting condition.
e Rotate the main dial to adjust the RTTY decoder
threshold level.
•Holddown[DEF]
F-6
for 1 second to select the de-
fault setting.
r Push [ADJ]
F-5
toexitfromthethresholdlevel
setting condition.
The UnShift On Space (USOS) function and new
line code can be set in the RTTY set mode.
(p. 4-18)
RTTY/PSK EXIT/SET
F-7
WIDE
F-2
HOLD/CLR
4
RECEIVE AND TRANSMIT
To Next Page
Loading...
Need help?
General
