9-3
■ Voice squelch control function
This function is useful when you don’t want unmodu-
lated signals pausing or cancelling a scan. When the
voice squelch control function is activated, the trans-
ceiver checks received signals for voice components.
If a received signal includes voice components, and
the tone of the voice components changes within 1
second, scan pauses (or stops). If the received signal
includes no voice components or the tone of the voice
components does not change within 1 second, scan
resumes.
➥ While a phone mode (SSB, AM or FM) is se-
lected,push[VSC]
(MF7)toswitchtheVSC(Voice
Squelch Control) function ON and OFF.
•“VSC”appearswhenthefunctionisactivated.
•TheVSCfunctionactivatesforanyscan.
•TheVSCfunctionresumesthescanonunmodu-
lated signals, regardless of whether the scan
resume condition is set to ON or OFF.
■ Scan set mode
When the squelch is open, scan continues until it is
stopped manually— it does not pause on detected
signals. When squelch is closed, scan stops when de-
tecting a signal, then resumes according to the scan
resume condition. Scan speed and the scan resume
condition can be set using the scan set mode.
q Push [SCAN]
F-5
to select scan screen.
w Push [SET]
F-7
to select scan set mode.
e
Push [Y]
F-1
or [Z]
F-2
to select the desired item.
r Rotate the main dial to select the desired condition.
•Holddown[DEF]
F-4
for 1 second to select the default
setting.
t Push
EXIT/SET
to return to scan menu.
Select the desired scan speed from high and low.
Main dial
F-4
DEF
F-1
∫
F-2
√
EXIT/SET
9
SCANS
•HIGH :scanisfaster
•LOW :scanisslower
Set the scan resume function ON or OFF. •ON :Whendetectingasignal,scanpausesfor10
seconds, then resumes. When a signal dis-
appears, scan resumes 2 seconds later.
•OFF:Whendetectingasignal,cancelsscanning.
To Next Page
Loading...
Need help?
General
