9-4
■ Programmed scan operation
q Push
EXIT/SET
several times to close a multi-func-
tion screen, if necessary.
wSelectVFOmode.
e Select the desired operating mode.
•Theoperatingmodecanalsobechangedwhilescan-
ning.
r Push [SCAN]
F-5
to select the scan screen.
t Set [SQL] open or closed.
•Seepage9-2forsquelchcondition.
y Push [PROG]
F-1
to start the programmed scan.
•“
” and decimal points blink while
scanning.
u When the scan detects a signal, scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch status.
i To cancel the scan, push [PROG]
F-1
.
•Rotatingthemaindialalsocancelsthescan.
o Hold down [RECALL]
F-6
for 1 second to recall
the frequency that is set before starting the scan, if
desired.
If the same frequencies are programmed into
the scan edge memory channel P1 and P2, pro-
grammed scan will not start.
■ ∂F scan operation
q Push
EXIT/SET
several times to close a multi-func-
tion screen, if necessary.
wSelectVFOmodeoramemorychannel.
e Select the desired operating mode.
•Theoperatingmodecanalsobechangedwhilescan-
ning.
r Push [SCAN]
F-5
to select the scan screen.
t Set the main band’s [SQL] open or closed.
•Seepage9-2forsquelchcondition.
y Set the ∂F span by pushing [∂F SPAN]
F-4
.
•±5kHz,±10kHz,±20kHz,±50kHz,±100kHz,±500
kHz and ±1000 kHz are selectable.
u Set center frequency of the ∂F span.
i Push [∂F]
F-2
to start the ∂F scan.
•“
” and decimal points blink while scanning.
o When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch status.
!0 To cancel the scan, push [∂F]
F-2
.
•Rotatingthemaindialalsocancelsthescan.
!1 Hold down [RECALL]
F-6
for 1 second to recall
the frequency that was set before starting the scan.
[SQL]
Main dial
EXIT/SET
F-1
PROG
[SQL]
Main dial
F-2
∂F
F-4
∂F SCAN
EXIT/SET
9
SCANS
To Next Page
Loading...
Need help?
General
