An SDHC card is supplied.
You can also use third party cards.
An SD card of up to 2 GB, or an SDHC of up to 32 GB,
can be used.
Icom has checked the compatibility with the following
SD and SDHC cards.
(As of March 2015)
Brand Type Memory size
SanDisk
®
SD 2 GB
SDHC
4 GB
8 GB
16 GB
32 GB
• The above list does not guarantee the card’s perfor-
mance.
• Throughout the rest of this document, the SD card
and an SDHC card are simply called SD cards or the
card.
• Icom recommends that you format all SD cards to be
used with the transceiver, even preformatted cards
for PCs or other uses. (p. 10-8)
Saving the transceiver’s factory default data is rec-
ommended. (p. 10-5)
NOTE:
• Before using the SD card, thoroughly read the card’s
instructions.
• If you do any of the following, the card data may be
corrupted or deleted.
- A power failure occurs or the AC power cable is
disconnected from an AC receptacle while access-
ing the card.
- You turn OFF the internal power supply while ac-
cessing the card.
- You remove the card from the transceiver while ac-
cessing the card.
- You drop, impact or vibrate the card.
• Do not touch the contacts of the card.
• The transceiver takes a longer time to recognize a
high capacity card.
• The card will get warm if used continuously for a
long period of time.
• The card has a certain lifetime, so data reading or
writing may not be possible after using it for a long
time period.
• When reading or writing data is impossible, the
card’s lifetime has ended. In this case, purchase a
new one. We recommend you make a backup file of
the important data onto your PC.
• Icom will not be responsible for any damage caused
by data corruption of an card.
About the SD card
D Inserting the SD card
Insert the card into the [SD CARD] slot until it locks
in place, and makes a ‘click’ sound.
• The indicator to the left of the [SD CARD] slot blinks.
NOTE: Before inserting, be sure to check the card
direction.
If the card is forcibly or inversely inserted, it will
damage the card and/or the slot.
D Removing the SD card
Push in the card until a click sounds, and then care-
fully pull it out.
• Before you remove the card while the transceiver’s pow-
er is ON, be sure to first unmount it. (p. 10-9)
To Next Page
Loading...
Need help?
General
