19-4
19
SPECIFICATIONS AND OPTIONS
Options
Approved Icom optional equipment is designed for optimal
performance when used with an Icom transceiver.
Icom is not responsible for the destruction or damage to an
Icom transceiver in the event the Icom transceiver is used
with equipment that is not manufactured or approved by
Icom.
IC-PW1/EURO h f
/50
m h
z
a l l b a n d
1
k
w l i n e a r
a m p l i f i e r
Full-duty-cycle 1 kW linear amplifier including an automatic
antenna tuner. Has automatic tuning and band selection ca-
pability when used with an Icom transceiver. Full break-in
(QSK) operation. The amplifier/power supply unit and the
remote control unit are separate.
SP-34 e x t e r n a l s p e a k e r
4 audio filters, headphone jack, can be connected to 2 trans-
ceivers.
• Input impedance: 8 Ω
• Max. input power: 5 W
SM-50 d e s k t o p m i c r o p h o n e
Unidirectional, dynamic micro-
phone for base station operation.
Includes [UP]/[DOWN] switches, a
low cut switch and mic gain con-
trol.
CT-17 c i -v l e v e l c o n v e r t e r
For remote transceiver control
using a PC. You can change fre-
quencies, operating mode, mem-
ory channels, etc. (software is not
included)
HM-36 h a n d m i c r o p h o n e
Hand microphone equipped with
[UP]/[DOWN] switches.
SP-33 e x t e r n a l s p e a k e r
Designed for base station operation.
• Input impedance: 8 Ω
• Maximum input power: 5 W
RS-BA1 ip r e m o t e c o n t r o l s o f t w a r e
To remotely control radios using the RS-BA1, BE SURE
that you comply with your local regulations.
SM-30 d e s k t o p m i c r o p h o n e
Unidirectional, electret microphone
for base station operation. Includes
a low cut switch and mic gain con-
trol.
To Next Page
Loading...
Need help?
General
