9
ABOUT THE microSD CARD
9-4
Formatting the microSD card
Use the transceiver's built-in Format function
to format all microSD cards to be used with the
transceiver. This creates a special folder on the card
that you need for operations like loading the data.
Format all cards, including a brand new microSD card,
and even preformatted cards for PCs or other uses.
NOTE: Formatting a card deletes all its data. Before
formatting any used card, back up its data onto your
PC. (p. 9-7)
IMPORTANT: Even if you format the microSD
card, some data may remain in the card. When you
dispose the card, be sure to physically destroy it to
avoid unauthorized access to any data that remains.
<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
(Menu > SD Card > SD Format)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select “SD Card,” then
push [OK].
3. Push [Up] or [Down] to select “SD Format,” then
push [OK].
• “Are you sure?” is displayed.
4. Push [Left] or [Right] to select <OK>, then push
[OK].
LTo cancel formatting, select <Cancel>.
• After formatting, returns to the “SD Card” screen.
5. Hold down [Back] for 1 second to return to the
standby screen.
Unmounting the microSD card
<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
(Menu > SD Card > SD Unmount)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select “SD Card,” then
push [OK].
3. Push [Up] or [Down] to select “SD Unmount,” then
push [OK].
• “Are you sure?” is displayed.
4. Push [Left] or [Right] to select <OK>, then push
[OK].
LTo cancel unmounting, select <Cancel>.
• After unmounting, returns to the “SD Card” screen.
5. Hold down [Back] for 1 second to return to the
standby screen.
6. Remove the card from the transceiver.
Before you remove a card when the transceiver is ON,
be sure to rst electrically unmount it, as shown below.
Otherwise the data may be corrupted or deleted.
TIP: For the Portable Non-Display types and
Mobile Segment types
Before removing a card, be sure to turn OFF the
transceiver.
To Next Page
Loading...
Need help?
General
