7
NXDN™ OPERATION
7-3
Transmitting a call
D Transmitting an Individual call
<Menu operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
(Menu > Signaling/Call > Call List Select)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select “Signaling/Call,”
then
push [OK].
3. Push [Up] or [Down] to select “Call List Select,”
then
push [OK].
4. Push [Up] or [Down] to select the Individual
station.
5. Push [PTT] to transmit an Individual call.
6. Hold down [PTT] and speak at your normal voice
level. Release [PTT] to receive.
TIP:
• You can transmit an Individual call through the Call
Menu. (Menu > Signaling/Call > Call menu)
• When an Individual ID is programmed in the
Memory CH, you can transmit the Individual call by
pushing [PTT] on the channel.
<Key operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
Using [Call List Select]:
1. Push [Call List Select] to display the “Call List
Select” screen.
2. Push [Up] or [Down] to select the Individual ID.
3. Push [PTT] to transmit an Individual call.
4. Hold down [PTT] and speak at your normal voice
level. Release [PTT] to receive.
Using [Individual]:
1. Push [Individual] to display the “Individual Select”
screen.
2. Push [Up] or [Down] to select the Individual
station.
3. Push [PTT] to transmit an Individual call.
4. Hold down [PTT] and speak at your normal voice
level. Release [PTT] to receive.
TIP: You can display the “Individual Select” screen
through the Menu screen.
(Menu > Signaling/Call > Individual Select)
NXDN operation enables you to make a call to a
specic station (Individual call) or to a particular group
(Group call). Other digital mode transceivers on the
channel will not receive a call that does not match
their Individual or Group ID and/or RAN (Radio Access
Number) code.
NOTE: When the handshake (repeater access) fails
within the specied time period after pushing [PTT],
the transceiver starts roaming.
To Next Page
Loading...
Need help?
General
