7
NXDN™ OPERATION
7-16
Receiving a call (Continued)
D Receiving a Stun, Kill or Revive
If a Stun or Kill command is received, the transceiver
will display “SORRY”*
1
and you cannot receive or
transmit*
2
.
When a Stun command is received, you cannot
operate the transceiver until a Revive command is
received or the password is input.
When a Kill command is received, you cannot operate
the transceiver until data programming is performed.
NOTE: Depending on the presetting, the transceiver
can ignore the Stun, Revive and Kill commands that
are from a non-specied station.
D Receiving an Emergency call
1. When an Emergency call is received:
• Beeps sound.
• “RX Emergency” and the calling station name (or ID)
are displayed.
*
1
• “ ” blinks.*
1
2. When the Send Ack function is turned ON,
the transceiver automatically transmits an
acknowledgement to the calling station, if the
received call type is a Group or All call.
L If the received call type is Individual, and it requests
an acknowledgment be sent back, the transceiver
automatically sends the acknowledgement.
3. Hold down [PTT], then speak into the microphone.
4. Turn OFF the transceiver, change the channel, or
push [PTT] or a key to stop the beep and display
indication.
*
1
Only for the Portable Ten-key and Simple key types and
the Mobile LCD types.
*
2
Depending on the presetting, reception may be enabled.
To Next Page
Loading...
Need help?
General
