4
ADVANCED OPERATION
4-2
DTMF calls
D Manual Dialing
A user can send DTMF codes.
While holding down [PTT], push the keys on the Ten-
key pad.
D Hot DTMF
A user can send DTMF codes using the Hot DTMF
function.
Without holding down [PTT], push the keys on the
Ten-key pad to send DTMF codes.
NOTE: Set the related settings using the CS-F3400D
programming software when using the Hot DTMF
function. See the Help le for details.
D Autodial
A user can quickly send DTMF tones that have been
pre-entered into the transceiver.
1. Push [DTMF Autodial] to display the “DTMF
Autodial” screen.
2. Push [Up] or [Down] to select a DTMF Memory.
3. Push [PTT] to send the selected DTMF Memory’s
codes.
• After sending, automatically returns to the standby
screen.
D Stun function
(Only for LTR operation)
The Stun function is used when a transceiver is stolen
or lost, and the function deactivates the transceiver.
When the transceiver receives a matching DTMF
code, the stun function is activated and the transceiver
operation is inhibited. In this case, entering the
password or reprogramming is necessary to operate
the transceiver again.
TIP: In the standby screen, a user can send the
currently selected DTMF Memory’s codes by
holding down [Autodial].
To Next Page
Loading...
Need help?
General
