Icom ID-800H User Manual

47
7
SCAN OPERATION
■ Skip channel setting
The memory skip function speeds up scanning by checking
only those memory channels not set as skip channels. Set
skip channels as follows.
q Select a memory channel:
➥ Push [M/CALL•PRIO] to select memory mode.
➥ Rotate [DIAL] to select the desired channel to be a skip
channel.
w Push
[SET•LOCK] to enter set mode.
• Rotate [DIAL] to select “SET,” if “CALLS” or “MESSAG” is dis-
played.
e Push [SET•LOCK] or [S.MW•MW] several times until
“CHS” appears as shown above.
r Rotate [DIAL] to turn the skip function ON or OFF for the
selected channel.
•“~” appears (CHS-ON); The channel is skipped during scan.
•“P ~” appears (CHS-ON); The channel is skipped during scan
and the programmed frequency is skipped during VFO scan,
such as programmed scan.
•“~” disappears (CHS-OF); The channel is scanned during
scan.
t Push any key below the display to exit set mode.
[
z Select a memory channel.
➥ Select memory mode by pushing [MR/CALL].
➥ Push [
YY
] or [
ZZ
] to select the desired channel
to be a skip channel.
• Direct memory channel selection is also available.
x Push [ SET B(D-OFF)] to enter set mode.
• Push [
YY
] or [
ZZ
] to select “SET,” if necessary.
c Push [ SET B(D-OFF)] or [ ENT C(T-OFF)] several
times until “CHS” appears as shown at left.
v Push [
YY
] or [
ZZ
] to set or cancel the skip setting.
• See item r at left for skip indicator details.
b Push [ CLR A(MW)] to exit set mode.
SET
B
The display shows that mem-
ory channel 16 is set as a skip
channel.
ID-800H_1.qxd 2007.06.14 3:09 PM Page 47

Icom ID-800H Specifications

General

Brand	Icom
Model	ID-800H
Category	Transceiver
Language	English