6 Parameter Description
-
178
-
6.1 Keypad
The parameters of the function menus displayed on the keypad are described as
follows:
■
F0: display of oor and running direction
fault occurs, the LEDs automatically display the fault code and blink. If the fault is
reset automatically, the F-0 menu is displayed.
Running direction
Present floor
Stop state
: No display
Running state: Up or down direction
displayed in a blinking manner
Fault state: Fault code displayed
■
F-1: command input of the running oor
and then press the SET button to save the setting. The elevator runs to the destination
.
■
F-2: fault reset and fault time and code display
change the setting to 1 or 2.
Then, the display automatically switches over to the F-0 menu.
display the 10 fault codes and occurrence time circularly. You can press the PRG
button to exit.
■
F-3: time display
After you enter the F-3 menu, the LEDs display the current system time circularly.
■
F-4: contract number display
■
F-5: running times display
After you enter the F-5 menu, the 7-segment LEDs display the elevator running times