Appendix A Foreign Standards
-
342
-
Appendix A Foreign Standards
A.1 Important Notes
CE mark
1) The CE mark indicates compliance with European safety and environmental
regulations. It is required for engaging in business and commerce (production,
import, and sales) in Europe. European standards include the Machinery
Directive for machine manufacturers, the Low Voltage Directive for electronics
manufacturers, and the EMC guidelines for controlling noise.
2) The NICE3000
new
is labeled with the CE mark based on the following EMC
guidelines and the Low Voltage Directive.
3) Low Voltage Directive: 2014/35/EU
4) EMC Guidelines: 2014/30/EU
5) Machines and devices used in combination with this controller must also be CE
6) The integrator who integrates the controller with the CE mark into other devices
has the responsibility of ensuring compliance with CE standards and verifying
that conditions meet European standards.
A.2 CE Low Voltage Directive Compliance
This controller has been tested according to IEC 61800-5-1: 2007, and it complies with
the Low Voltage Directive.
To enable machines and devices integrating this controller to comply with the Low
Voltage Directive, be sure to meet the following conditions.
A.2.1 Mounting Location
Mount the controller in places with pollution not higher than severity 2 and
overvoltage category 3 in accordance with IEC60664.
A.2.2 Installing Fuse on the Input Side
To prevent accidents caused by short circuit, install fuse on the input side and the fuse
must comply with the UL standard. Select the fuse according to Table 3-2 Peripheral
device selection of the NICE3000
new
.
For input current and output current of the controller, refer to Table 1-1 Main technical
data of NICE3000
new
.
For the recommended fuse models, refer to 3.2.1 Selection Guide of Cable, Circuit
Breaker, and Contactor.
To Next Page
Loading...
Need help?
General
