6 Parameter Description
-
246
-
parameter is valid when the manual door function is used.
FB-17 is used to set the holding time before forced door close is implemented.
If the forced door close function is enabled, the system enters the forced door close
state and sends a forced door close signal when there is no door close signal after the
time set in this parameter is reached.
Function
Code
Name Setting Range Default Unit Property
Fb-20 Manual door lock waiting time 0 to 60 0 s
☆
This parameter is used to set interval time to wait from door lock unlocking and
locking to the next running startup in the case of manual door.
Function
Code
Name Setting Range Default Unit Property
Fb-24 UCMP test program version 0 to 65535 1 -
Fb-24 is the program version of the UCMP test program module.
Group FC: Protection function parameters
Function
Code
Name Setting Range Default Unit Property
FC-00 F5-33 Program control selection 0 to 65535 0 -
★
These parameters are used to select program control functions. If a bit is set to 1, the
function indicated by this bit is enabled; if this bit is set to 0, the function is disabled.
FC-00 Program control selection
Bit Function Description Default
Bit0
Detection of short
circuit to ground at
power-on
Whether the motor is short circuited to ground
is detected at power-on. If the motor is short
circuited to ground, the controller blocks the output
immediately, and reports the fault.
1
Bit1 Reserved - 0
Bit2
Decelerating to
stop at valid light
curtain
During normal-speed running, the elevator
decelerates to stop immediately after the light
curtain acts, and then runs to the registered
function is mainly used in the case of manual door.
0
To Next Page
Loading...
Need help?
General
