7 Troubleshooting
-
266
-
7.3 Description of Fault Levels
The NICE3000
new
has almost 70 pieces of alarm information and protective functions.
It monitors various input signals, running conditions and feedback signals. If a fault
occurs, the system implements the relevant protective function and displays the fault
code.
The controller is a complicated electronic control system and the displayed fault infor-
are handled according to the following table.
Fault Levels
Fault Level Fault State Solution
Level 1
◆
Display the fault code.
◆
Output the fault relay action com-
mand.
◆
Level 2
◆
Display the fault code.
◆
Output the fault relay action com-
mand.
◆
Continue normal running of the ele-
vator.
◆
function is disabled.
◆
-
ing function is disabled.
Level 3
◆
Display the fault code.
◆
Output the fault relay action com-
mand.
◆
Stop output and apply the brake
immediately after stop.
◆
elevator stops at special deceler-
ation rate, and cannot restart.
◆
elevator does not stop. In nor-
mal-speed running, the elevator
stops, and then can start running
at low speed after a delay of 3s.
Level 4
◆
Display the fault code.
◆
Output the fault relay action com-
mand.
◆
In distance control, the elevator
decelerates to stop and cannot run
again.
◆
elevator stops at special deceler-
ation rate, and cannot restart.
◆
elevator does not stop. In nor-
mal-speed running, the elevator
stops, and then can start running
at low speed after a delay of 3s.
◆
elevator does not stop. In nor-
mal-speed running, the elevator
stops, and then can start running
at low speed after a delay of 3s.
Level 5
◆
Display the fault code.
◆
Output the fault relay action com-
mand.
◆
The elevator stops immediately.
◆
elevator stops immediately and
cannot restart.
◆
elevator does not stop. In nor-
mal-speed running, the elevator
stops, and then can start running
at low speed after a delay of 3s.
To Next Page
Loading...
Need help?
General
