6 Parameter Description
-
257
-
Group FP: User parameters
Function
Code
Name Setting Range Default Unit Property
FP-00 User password 0 to 65535 0 -
☆
FP-00 is used to set the user password. 0 indicates no password.
The password prohibits unauthorized personnel from viewing and modifying
parameters. If it is set to any non-zero number, the password protection function is
password in order to enter the menu. If the entered password is incorrect, you cannot
view or modify parameters.
If FP-00 is set to 00000, the previously set user password is cleared, and the password
protection function is disabled.
■
Remember the password that you set. If the password is set incorrectly or forgotten,
contact Inovance to replace the control board.
Function
Code
Name Setting Range Default Unit Property
FP-01 Parameter update
0: No operation
1: Restore default setting
2: Clear fault records
3: Clear shaft data
0 -
★
FP-01 is used to reset some system parameters.
The values are as follows:
■
0: None
■
1: Restore default setting. All parameters except group F1 are restored to the default
settings. Be cautions with this setting.
■
2: Clear fault records. Fault records are cleared. FC-11 to FC
-
210 and parameters in
groups E0 to E9 are set to 0.
■
3: Clear shaft information: Floor pulse data in the shaft is cleared. Shaft pulses of
F3-12 to F3-17 and group F4 are set to 0. The leveling adjustment parameters in
group Fr are set to 30030. Shaft auto-tuning must be performed again after clearing.
Function
Code
Name Setting Range Default Unit Property
FP-02
display
0: Invalid
1: Valid
0 -
★
To Next Page
Loading...
Need help?
General
