– 114 –
<Sewing screen (Maintenance personnel mode)>
<Sewing data edit screen>
1) Press
❶
on the sewing screen
under the maintenance personnel
mode.
The "sewing data edit screen" is dis-
played.
2) Press
❷
.
The "Thread clamp setting screen" is
displayed.
8-7. Adjusting the thread clamp device (* excluding the F type model)
①
As same as the conventional wiper device, the
thread clamp device is able to roll in the needle
thread on the wrong side of material.
[Features]
So-called "bird's nest phenomenon" which occurs
on the wrong side of material can be reduced by
using thread clamp device
①
and condensation
stitching in combination.
* Operability around the needle entry area is
improved.
intended for the needle entry area is improved.
❶
❷
To Next Page
Loading...
Need help?
General
