– 158 –
9-5-3. Condensation custom edit function
①
Selecting the condensation custom edit function
Display the "Condensation custom pattern
list screen" Refer to
"9-5-2. Creating a new
condensation custom"p.155
.
<Condensation custom edit screen>
②
Editing the condensation custom value
In this section, procedure for editing the condensation custom value is described.
Refer to
"9-5-2. Creating a new condensation custom"p.155
for the explanation of screen.
1) In the case of setting the number of stitches
The number of stitches can be input in the range from 1 to 100.
Change the number of stitches for step 1 using the numeric keypad and or the num-
ber of stitches.
Press
2) In the case of setting the stitch length
Possible input range is same as that of "S003 Stitch length".
Change the stitch length for step 1 using the numeric keypad and the stitch length.
Press
* A negative number of stitches can also be set. In this case, the direction of feed is reverse direc-
tion.
3) Change the settings for each step in the same manner as described above.
Steps of procedure to be taken after the aforementioned step are same as those described in
"9-5-2.
Creating a new condensation custom"p.155
.
To Next Page
Loading...
Need help?
General
