– 155 –
9-5. Condensation custom pattern
Condensation stitches can be sewn while specifying
needle entry points as desired, by setting a conden-
sation custom. As many as 20 steps can be created
in one pattern. The maximum number of patterns that
can be registered is nine.
9-5-1. Selecting the condensation custom
Select condensation custom pattern Refer to
"5-2-3. (2) ♦In the case of maintenance personnel
mode" p.45
.
The condensation custom pattern for reverse-feed stitching at the end of sewing can be set in the simi-
lar manner.
Step 1
1 mm 3 stitches
Step 2
1.5 mm 4 stitches
Step 3
1 mm 3 stitches
Step 5
1.5 mm
2 stitches
Step 4
‒1 mm 3 stitches
Condensation custom pattern
9-5-2. Creating a new condensation custom
①
Selecting the condensation custom pattern setting on the mode screen
1) Press
❶
.
The "mode screen" is displayed.
2) Select the "5. Condensation custom
sewing setting".
The "condensation custom pattern list
screen" is displayed.
<Mode screen>
1. With some combinations of stitch
length, direction of feed and sewing
speed, the sewing machine may fail to
nish a sewing pattern exactly accord-
ing to the settings.
2. Needle cannot be entered to the same
needle entry point when the stitch
length is set to 0.0 mm.
<Figure: Example of the condensation custom>
❶
To Next Page
Loading...
Need help?
General
