Juniper E Series User Manual

E-series Hardware Guide
178 ! Installing Software When a Firewall Does Not Exist
3. Access the Privileged Exec CLI command mode.
4. Configure IP on an interface.
5. Configure access to the network host.
6. Mount the CD on the network host.
7. Copy the software release file to the E-series router.
8. Save the current configuration.
9. Reboot the system.
Task 1: Obtain the Required Information
Before you install the software, obtain the following information:
! The password (if one is configured) that allows you to access Privileged Exec
mode on the E-series router
! The IP address of the network host
! The IP address of the E-series router
! The IP address of the next hop to reach the destination network (for example, a
gateway)
! The login name and password for the FTP server
! The procedure for mounting a CD on the network host
Task 2: Divert Network Traffic to Another Router
The system will be unavailable during the installation process.
Task 3: Access Privileged Exec Mode
To access this mode via the CLI:
1. Issue the enable command.
host1>enable
2. Type the password if the system prompts you.
Task 4: Configure IP on an Interface
Typically, you configure IP on the Fast Ethernet interface of the SRP module. To
configure IP on an interface:
1. Determine the slot number of the module.
host1#show version

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English