Juniper E Series User Manual

E-series Routers ! 7
Chapter 1: E-series Overview
Figure 5: ERX-14xx model, rear view
ERX-7xx Models
The ERX-7xx models are robust, high-density routers with less capacity than the
ERX-14xx models. The ERX-7xx models use either the SRP-10G module or the
SRP-5G module.
You can configure the ERX-7xx models to enable the line modules to operate either
at full line rate performance or at a rate dependent on the resources available. For
information about configuring performance of line modules, see JUNOSe System
Basics Configuration Guide, Chapter 5, Managing Line Modules and SRP Modules.
NOTE: In the E-series documentation, the term ERX-7xx models refers to both the
ERX-705 router and the ERX-710 router. The terms ERX-705 router and ERX-710
router refer to the specific models. See Figure 6 and Figure 7.
I/O
module
Power input
module
Cable
management
bracket
Plenum
Fan tray
SRP I/O
module
g013727
NOTE: The 10-Gbps SRP module used in the ERX-310 router is different from the
10-Gbps SRP module used in the ERX-710 router. See section SRP Module, later in
this chapter, for more information.

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English