Installing SRP I/O and SRP Modules ! 45
Chapter 5: Installing Modules
Installing an SRP I/O Module
To install an SRP I/O module:
1. Ground yourself by using an antistatic wrist strap or other device.
2. With a Phillips screwdriver, loosen the captive screws that secure the blank
faceplate covering the empty chassis slot, if present, and remove the faceplate.
3. Remove the SRP I/O module from its antistatic bag.
4. Slide the module into the chassis by placing it between the guides of the
selected slot and pushing the module until it stops.
5. Tighten the module’s captive screws using a Phillips screwdriver. Turn both
screws several times before tightening them completely to allow the module to
sit correctly.
Installing an SRP Module
To install an SRP module:
1. Ground yourself by using an antistatic wrist strap or other device.
2. Choose the slot in which you want to install the module.
! ERX-14xx models – slot 6 or 7
! ERX-7xx models – slot 0 or 1
! ERX-310 router – slot 0
3. With a Phillips screwdriver, loosen the captive screws that secure the blank
faceplate covering the empty chassis slot, if present, and remove the faceplate.
NOTE: Because of different physical dimensions and switch fabric capabilities, SRP
modules are not interchangeable between systems. For example, the 10-Gbps SRP
module used in ERX-7xx/14xx models cannot be used in an ERX-310 router, and
vice versa.
NOTE: Install the SRP I/O module before you install the SRP module; otherwise, the
system diagnostics will fail.
NOTE: See figures in Chapter 1, E-series Overview, for module locations.
NOTE: See figures in Chapter 1, E-series Overview, for module locations.
To Next Page
Loading...
Need help?
General
