E-series Hardware Guide
80 ! Telnet Setup
2. Set an IP address on the Ethernet interface:
! Substitute the slot number where the SRP module is located for the
slotnumber variable.
! Use an IP address valid for the system.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#interface FastEthernet slotnumber/0
host1(config-if)#ip address 10.10.7.3 255.255.255.0
3. Continue to configure the system’s parameters as needed.
After you have assigned an IP address to the system, you can communicate
remotely by running Telnet over an Ethernet network. See the next section, Telnet
Setup.
Telnet Setup
When you have configured an IP address for the system, you can run Telnet from a
host to access the system through its Ethernet port. To connect the Ethernet port to
the network:
1. Connect an Ethernet cable (RJ-45) to the system’s 10/100Base-T (RJ-45) port on
the SRP I/O module.
2. Connect the other end of the cable to the appropriate Ethernet network for an
out-of-band connection.
Before you can access the system with Telnet, you must either configure a password
for Telnet access or disable the password requirement from the management
console. In the following example, you disable the password.
1. Enter the enable command.
host1>enable
host1#
The system is now in Privileged Exec mode.
2. Enter the configure command.
host1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#
The system is now in Global Configuration mode.
3. Enter the line command.
host1(config)#line vty 0 4
host1(config-line)#
The system is now in Line Configuration mode.
To Next Page
Loading...
Need help?
General
