Juniper E Series User Manual

E-series Hardware Guide
128 ! I/O Module Specifications
I/O Module Specifications
See Table 22 on the following pages for I/O module details such as module type,
E-series model compatibility, SRP module compatibility, number of ports, connector
type, and cabling specifications.
Table 22: I/O module specifications
I/O Module
Label
a
Type
Model
Compatibility
SRP Module
Compatibility
No. of Ports
Connector
Type
Cabling Specifications
CE1
CE1
FULL
I/O
Non-ASIC ERX-7xx models
ERX-1410 router
SRP-5G
SRP-5G+
SRP-10G
20
! RJ-48C,120
ohm
! BNC, 75
ohm via a
balun panel
that
connects to
the I/O
module
! Use shielded cables to
maintain EMC compliance.
! The transmitted signal
complies with ITUT G.703,
Physical/electrical
characteristics of hierarchical
digital interfaces (November
2001) for cable lengths up to
450 m (492 yards).
cOC3/STM1
cOC3
STM1
F0 I/O
MULTI
MODE
ASIC ERX-7xx models
ERX-14xx models
ERX-310 router
SRP-5G+
SRP-10G
SRP-40G
SRP-40G+
SRP-SE10G
4 SC full duplex
! Tx power:
! min: –19 dBm
! max: –14 dBm
! Center wavelength: 1310 nm
! Rx input power:
! min: –30 dBm
! max: –14 dBm
! Rated for 2 km (1.2 miles)
over 62.5-micron core cable
with an optical loss of 0–9 dB
or 50-micron core cable with
an optical loss of 7 dB
cOC3
STM1
F0 I/O
SINGLE
MODE
ASIC ERX-7xx models
ERX-14xx models
ERX-310 router
SRP-5G+
SRP-10G
SRP-40G
SRP-40G+
SRP-SE10G
4 SC full duplex
! Tx power:
! min: –15 dBm
! max: –8 dBm
! Center wavelength: 1310 nm
! Rx input power:
! min: –31 dBm
! max: –8 dBm
! Rated for 15 km (9.3 miles) of
9-micron core cable

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English