Juniper E Series User Manual

E-series Hardware Guide
62 ! Cabling the E-series Router for Power
Table 9: Power input module cables/wires needed
Cable/Wire From To
ERX-14xx models
One 10-AWG ground wire Power input module ground
terminal
Termination ground
Two 6-AWG wire leads Power input module Power A
–48 VDC and RTN leads
Appropriate leads on power
source No. 1
Two 6-AWG wire leads Power input module Power B
–48 VDC and RTN leads
Appropriate leads on power
source No. 2
ERX-7xx models
One 10-AWG ground wire Power input module ground
terminal
Termination ground
Two 10-AWG wire leads Power input module Power A
–48 VDC and RTN leads
Appropriate leads on power
source No. 1
Two 10-AWG wire leads Power input module Power B
–48 VDC and RTN leads
Appropriate leads on power
source No. 2
ERX-310 router
One 10-AWG ground wire Power input module ground
terminal
Termination ground
Two 14-AWG wire leads
NOTE: DC model only
Power input module Power A
–48 VDC and RTN leads
Appropriate leads on power
source No. 1
Two 14-AWG wire leads
NOTE: DC model only
Power input module Power B
–48 VDC and RTN leads
Appropriate leads on power
source No. 2
One AC power cord
NOTE: AC model only
Power input module AC power IEC
receptacle
Appropriate AC power
supply

Juniper E Series Specifications

General

Brand	Juniper
Model	E Series
Category	Network Router
Language	English