Keithley SourceMeter 2400 User Manual

18-22 SCPI Command Reference 2400 Series SourceMeter
®
User’s Manual
Table 18-11
TRIGger command summary
Command Description
Default
parameter SCPI
:INITiate[:IMMediate]
:ABORt
:ARM
[:SEQuence[1]]
[:LAYer[1]]
:COUNt <n>
:COUNt?
:SOURce <name>
:SOURce?
:TIMer <n>
:TIMer?
[:TCONfigure]
:DIRection <name>
:DIRection?
[:ASYNchronous]
:ILINe <n>
:ILINe?
:OLINe <n>
:OLINe?
:OUTPut <name>
:OUTPut?
:TRIGger
:CLEar
[:SEQuence[1]]
:COUNt <n>
:COUNt?
:DELay <n>
:DELay?
:SOURce <name>
:SOURce?
Initiate source-measure cycle(s).
Reset trigger system. Goes to idle state.
Path to program Arm Layer:
Specify arm count (1 to 2500 or INFinite).
Query arm count (INFinite = +9.9e37).
Specify control source (IMMediate, TIMer,
MANual, BUS, TLINk, NSTest, PSTest, or
BSTest).
Query control source.
Set timer interval in seconds (0.001 to
99999.99).
Query timer interval.
Enable (SOURce) or disable (ACCeptor)
bypass.
Query state of bypass.
Configure output triggers:
Select input trigger line (1, 2, 3, or 4).
Query input trigger line.
Select output trigger line (1, 2, 3, or 4).
Query output trigger line.
Output trigger (TENTer, TEXit, or NONE).
Query arm output trigger status.
Path to program Trigger Layer:
Clear any pending input triggers immediately.
Specify trigger count (1 to 2500).
Query trigger count.
Specify trigger delay: 0 to 999.9999 (sec).
1
Query source delay.
Specify control source (IMMediate or TLINk).
Query control source.
1
IMMediate
0.1
ACCeptor
1
2
NONE
1
0
IMMediate
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
1. For the Model 2430 Pulse Mode, trigger delay is not used. This command is ignored.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Keithley SourceMeter 2400 Specifications

General

Brand	Keithley
Model	SourceMeter 2400
Category	Measuring Instruments
Language	English