Installation
1. Install clean or new, main filter element into air
cleaner and secure with wing nut. Tighten wing
nut hand tight, do not use a wrench or pliers.
2. If filter element is being reused, make sure main
element (10) is not damaged, the gasket must seal
completely.
SAFETY FILTER ELEMENT
Have a new safety (secondary) filter element on
hand before removing old one. Do not keep intake
system open to the atmosphere any longer than
absolutely necessary.
Removal
The function of the safety filter is to increase overall
reliability and engine protection. If the safety element
indicator shows red the element has become clogged,
and should be discarded and replaced with a new one.
1. Shut down the engine. Clean the dirt and dust off
the element end cover.
2. Loosen wing nut (5, Figure 5-2) and remove end
cover (8) and main element (10).
3. Remove indicator nut (7) holding safety element
in place. Remove safety element (9). Inspect gas-
ket (14) and replace if necessary.
4. Remove any dust lodged in the clean air outlet and
around element sealing surface.
90109
FIGURE 5-2. AIR CLEANER ASSEMBLY
1. Dust Cap
2. Dust Cap Gasket
3. Tube
4. Unfiltered Air Inlet
5. Wing Nut
6. Wing Nut Gasket
7. Safety Element Indicator
8. End Cover
9. Safety Filter Element
10. Main Filter Element
11. Main Element Gasket
12. Clean Air Outlet
13. Pre-Cleaner Gasket
14. Safety Filter Element
Gasket
Safety Element Indicator
91186
C5-2 Air Filtration System C05012 4/98
To Next Page
Loading...
Need help?
General
