COMBINATION INSTRUMENT 7
27
7.5 Setting the clock
Condition
The motorcycle is stationary.
400330-01
– Repeatedly press the button briefly until CLK appears at the
bottom right of the display.
– Press the button for 2–3 seconds.
The hour display flashes.
– Adjust hour display with the button and/or button .
– Wait 3 - 5 seconds.
The next segment of the display flashes and can be set.
– You can set the following segments in the same way as the
hours by pressing the button and the button .
Info
The seconds can only be set to zero.
If no button is pressed for 15–20 seconds, or if an
impulse comes from the wheel speed sensor, the
settings are automatically saved and the setup menu is
closed.
7.6 Viewing the lap time
Info
This function can only be opened if lap times have actually been timed.
Condition
The motorcycle is stationary.
400321-01
– Repeatedly press the button briefly until LAP appears at the
bottom right of the display.
– Briefly press the button .
LAP 1 appears on the left side of the display.
– The laps 1 - 10 can be viewed with the button .
– Press and hold the button for 3 - 5 seconds.
The lap times are deleted.
– Briefly press the button .
Next display mode
Info
When an impulse is received from the wheel speed sen-
sor, the left side of the display changes back to the
SPEED mode.
To Next Page
Loading...
Need help?
General
