2. To check the engine-oil-level, draw out the dipstick.
3.
Wipe the dipstick clean.
4.
Replace the dipstick.
5. Draw the dipstick out again.
6. Check to see that the engine-oil-level lies between
the 2 notches.
7. If the engine-oil-level is too low, add new engine oil
to the prescribed level at the oil inlet.
(See LUBRICANTS, FUEL, AND COOLANT on
page 90)
(1) Oil inlet
(2) Dipstick
(A)
Range which engine oil level
is acceptable within
IMPORTANT :
• When using
an engine oil of different maker
or viscosity from the previous one, remove
all of the old engine oil.
Never mix 2 different types of engine oil.
• If the engine oil level is low, do not run the
engine.
NOTE :
• At times a small amount of fuel, which is
used to regenerate the DPF, may get mixed
with the engine oil and the engine oil may
increase in volume.
6. Checking the transmission fluid
level
WARNING
To avoid personal injury or death:
•
Park the tractor on a firm, flat, and level surface,
lower the implement to the ground, and shut off
the engine before checking the transmission-
fluid-level.
IMPORTANT :
• If the transmission-oil-level is low, do not run
the engine.
1. Park
the machine on a flat surface, lower the
implement and shut of
f the engine.
2. To check the transmission-fluid-level, draw out the
dipstick.
3. Wipe the dipstick clean.
4. Replace the dipstick.
5. Draw the dipstick out again.
6. Check to see that the transmission-oil-level lies
between the 2 notches.
DAILY CHECK PERIODIC SERVICE
To Next Page
Loading...
Need help?
General
