EasyManuals Logo

Kubota L3901 User Manual

Kubota L3901
139 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #126 background imageLoading...
Page #126 background image
2. Replacing the fuel line
Consult your local KUBOT
A Dealer for replacing the
fuel hose.
3. Replacing the intake air line
Consult your local KUBOTA Dealer for replacing the
intake-air-line.
4. Replacing the oil cooler line [HST
type only]
Consult your local KUBOTA Dealer for replacing the
oil-cooler-line.
5. Replacing the oil separator hose
Consult your local KUBOTA Dealer for replacing the
oil-separator-hose.
6. Replacing the power steering
hose [Manual transmission type
only]
Consult your local KUBOTA Dealer for replacing the
power-steering-hose.
SERVICING AS REQUIRED
1. Bleeding the fuel system
Remove the air in the following cases.
When the fuel filter or lines are removed.
When water is drained from the water separator.
When the fuel tank is completely empty.
After you has not use the tractor for a long period of
time.
1. Fill the fuel tank with fuel, and open the fuel shutoff-
valve.
(1) Fuel shutoff-valve (A) Close
(B) Open
2.
Loosen the
air-vent-plug on the fuel filter 2 turns or
so.
(1) Air vent plug
3. Turn on the key switch and wait for about 1 minute.
Then tighten up the air-vent-plug.
4.
Set the hand-throttle-lever at the minimum speed
position and turn the starter key to the “START”
position.
5. If the engine does not start, try step 4. several times
at 30 second intervals.
IMPORTANT :
Do not hold key switch at engine start
position for more than 10 seconds
continuously. If more engine cranking is
needed, try again after 30 seconds.
6. Accelerate the engine to remove the small portion
of air left in the fuel system.
7. If air still remains and the engine stops, repeat the
preceding steps.
2. Draining the water from the clutch
housing
After operating in rain, snow, or the tractor has been
washed, water may get into the clutch housing.
1. Check if water has entered into the clutch housing
by pushing in the split pin.
2.
If water has entered into the clutch housing, remove
the split-pin-plug and drain the water.
The tractor is equipped with split-pin-plug under the
clutch housing.
 PERIODIC SERVICE SERVICE EVERY 4 YEARS
122
L3301,L3901

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota L3901 and is the answer not in the manual?

Kubota L3901 Specifications

General IconGeneral
Engine TypeDiesel
Engine Horsepower37.5 HP
3-Point HitchCategory I
Weight2, 623 lbs (Gear Drive), 2, 778 lbs (Hydrostatic)
Displacement111.4 cu in
Cylinders3
Displacement (cu in)111.4
Hydraulic System TypeOpen center
Width55.1 inches
Transmission TypeGear or HST
Fuel Capacity11.1 gal
Gears8 forward, 4 reverse (Gear)
Number of Gears8 forward, 4 reverse
Fuel Tank Capacity11.1 gal
Lift Capacity at 24"1433 lbs
Height91.7 inches
Tire Size (Front)7-16
Tire Size (Rear)11.2-24
Engine ModelD1803

Related product manuals