7. If
the transmission-oil-level is too low, add new
transmission
oil to the prescribed level at the oil
inlet.
(See LUBRICANTS, FUEL, AND COOLANT on
page 90.)
[Manual transmission type]
(1) Dipstick (A) Range which transmission
oil level is acceptable within
[HST type]
(1) Dipstick (A) Range which transmission
oil level is acceptable within
(2) Oil inlet
7. Checking the coolant level
WARNING
To avoid personal injury or death:
•
Be sure to stop the engine and remove the
starter key before checking the coolant level.
• Do not remove the radiator cap while the
coolant is hot. When the coolant is cool, slowly
rotate the radiator cap to the first stop and allow
sufficient time for excess pressure to escape
before removing the radiator cap completely.
1. Check to see that the coolant level is between the
“FULL”
and the “LOW” marks of the recovery tank.
2. When the coolant level drops due to evaporation,
add soft water only up to the full level.
In case of leakage, add antifreeze and soft water in
the specified mixing ratio up to the full level.
(See Flushing the cooling system and changing the
coolant on page 117)
IMPORTANT :
• Use clean, fresh soft water and antifreeze to
fill the radiator.
• If coolant should leak, consult your local
KUBOTA Dealer.
3. When the coolant level is lower than the “LOW”
mark of the recovery tank, remove the radiator cap
and check to see that the coolant level is just below
the port.
If the coolant level is low, add coolant.
(1) Recovery tank (A) Full
(B) Low
IMPORT
ANT :
• If Y
ou have to remove the radiator cap,
follow the preceding warning and securely
retighten the radiator cap.
8. Cleaning the evacuator valve
1. Open the evacuator valve.
PERIODIC SERVICE DAILY CHECK
To Next Page
Loading...
Need help?
General
