10. Fully depress the clutch pedal.
(1) Clutch pedal
11. Turn the starter key to the “ST
ART” position and
release it when the engine starts.
IMPORTANT :
• Because of safety devices, the engine will
not start except the following conditions:
– PTO-gear-shift-lever is placed in the
“OFF” position.
– Speed-control-pedal is placed in the
“NEUTRAL” position.
12. Check to see that all the lamps on the Easy
Checker
™
are “OFF”.
If the lamps on the Easy Checker
™
is still on,
immediately stop the engine and determine the
cause.
13. Release the clutch pedal.
STARTING THE ENGINE IN
COLD WEATHER
If
the ambient temperature is as follows and the engine
is very
cold, follow the procedure in this section to start
the engine.
Ambient temperature Below -5 ℃ (23 ℉)
1. Take the following steps of the procedure in the
Starting the engine section.
• [Manual transmission type]
T
ake the step 1. through step 9. of the
procedure in STARTING THE ENGINE
[MANUAL TRANSMISSION TYPE] on page 51.
• [HST type]
Take the step 1. through step 9. of the
procedure in STARTING THE ENGINE [HST
TYPE] on page 53.
2. Turn the starter key to the “ON” (glow plug) position
and keep it there for 10 seconds.
To protect the battery and the starter, make sure
that the starter is not continuously turned for more
than 10 seconds.
(A) Off
(B) On
(C)
Start
NOTE :
• Glow-plug-indicator comes
on while the
engine is being preheated.
(1) Glow plug indicator
3. Turn the starter key to the “STAR
T” position.
The engine should start.
If the engine fails to start after keeping the starter
key preheat position for 10 seconds, turn off the
starter key for 30 seconds. Then repeat step 2. and
step 3.
1. Antifrost heater for oil separator
(if equipped)
The heater element operates continuously when the
key switch is in the on or start position.
Due to
high electrical draw, extended idle time or
operations will drain the battery and stop the tractor.
STARTING THE ENGINE IN COLD WEATHER OPERATING THE ENGINE
To Next Page
Loading...
Need help?
General
