Kubota L3901 User Manual

2. Lubricating the grease fittings
[4WD]
1. Apply a
small amount of multipurpose grease to the
following points every 50 hours.
If you have operated the machine in extremely wet
and muddy conditions, lubricate the grease fittings
more often.
(1) Grease fitting (pedal shaft)
(2) Grease fitting (top link)
(3)
Grease fitting (lifting rod)
[RH]
(4) Battery terminals
(5) Grease fitting (tie-rod ends)
2. When applying the grease to the forward front-axle-
support, follow the following the procedure.
a.
Remove the breather plug.
b. Apply grease until the grease overflows from
the breather-plug-port.
c. After greasing, reinstall the breather plug.
(1) Grease fitting (front axle sup-
port)
(2) Breather plug
3. Checking the engine start system
[Manual transmission type]
WARNING
To avoid personal injury or death:
•
Do not allow anyone near the tractor while
testing.
• If the tractor does not pass the test, do not
operate the tractor.
Preparation before testing
1. Place all the control levers in the “NEUTRAL”
position.
2. Set the parking brake and stop the engine.
PERIODIC SERVICE SERVICE EVERY 50 HOURS
102
L3301,L3901

Kubota L3901 Specifications

General

Engine Type	Diesel
Engine Horsepower	37.5 HP
3-Point Hitch	Category I
Weight	2, 623 lbs (Gear Drive), 2, 778 lbs (Hydrostatic)
Displacement	111.4 cu in
Cylinders	3
Displacement (cu in)	111.4
Hydraulic System Type	Open center
Width	55.1 inches
Transmission Type	Gear or HST
Fuel Capacity	11.1 gal
Gears	8 forward, 4 reverse (Gear)
Number of Gears	8 forward, 4 reverse
Fuel Tank Capacity	11.1 gal
Lift Capacity at 24"	1433 lbs
Height	91.7 inches
Tire Size (Front)	7-16
Tire Size (Rear)	11.2-24
Engine Model	D1803