Kubota L3901 User Manual

6. If
the distance between the tire beads at front of tire
is
not shorter than the distance between the tire
beads at rear of tire, adjust the length of tie rod.
(See Adjusting the toe-in on page 110)
(A) Wheel-to-wheel distance at
rear
(B) Wheel-to-wheel distance at
front
(C)
Front
Proper toe-in
2 mm to 8 mm
(0.08 in. to 0.31 in.)
2.1 Adjusting the toe-in
1. Loosen the lock nuts.
2. Turn the turnbuckle to adjust the length of tie rod
until the proper toe-in measurement is obtained.
3. Retighten the lock nuts.
(1) Lock nuts
(2) T
urnbuckle
(3) Tie rod
[A] 2WD
[B] 4WD
SERVICE EVERY 400 HOURS
1. Changing the engine oil
WARNING
To avoid personal injury or death:
•
Be sure to stop the engine and remove the
starter key before changing the engine oil.
• Allow the engine to cool down sufficiently
because the engine oil can be hot and can burn.
1. To drain the used engine oil, remove the drain plug
at
the bottom of the engine and drain the engine oil
completely into the oil pan.
2. After draining the engine oil, reinstall the drain plug.
PERIODIC SERVICE SERVICE EVERY 200 HOURS
110
L3301,L3901

Kubota L3901 Specifications

General

Engine Type	Diesel
Engine Horsepower	37.5 HP
3-Point Hitch	Category I
Weight	2, 623 lbs (Gear Drive), 2, 778 lbs (Hydrostatic)
Displacement	111.4 cu in
Cylinders	3
Displacement (cu in)	111.4
Hydraulic System Type	Open center
Width	55.1 inches
Transmission Type	Gear or HST
Fuel Capacity	11.1 gal
Gears	8 forward, 4 reverse (Gear)
Number of Gears	8 forward, 4 reverse
Fuel Tank Capacity	11.1 gal
Lift Capacity at 24"	1433 lbs
Height	91.7 inches
Tire Size (Front)	7-16
Tire Size (Rear)	11.2-24
Engine Model	D1803