15. REAR WHEEL/AXLE/SUSPENSION/
DRIVING MECHANISM
15-26
MXU 300/250
REAR AXLE INSPECTION:
Check the axle splines for wear or damage.
Set the axle in V-blocks and measure the
runout with a dial indicator.
Axle runout is 1/2 the total indicator reding.
Service limit: 3 mm (0.12 in)
FINAL GEAR CASE INSPECTION:
Turn the pinion gear and check that the gear
turns smoothly and quietly without binding.
If the gears do not turn smoothly or quietly,
the gears and/or bearing may be damaged or
faulty. Replace the final gear case assembly
if necessary.
FINAL DRIVE SHIM (MXU 300)
ADJUSTMENT/FINAL GEAR
CASE (MXU 300) DISASSEMBLY
BACKLASH
Hold the pinion gear with the special tool.
Special tool:
Pinion puller set F014
Set the final gear into a jig or vise with soft
jaws.
Pinion Puller Se
To Next Page
Loading...
Need help?
General
