Maintenance
menu
Items Description
Adjust print
quality
Drum charge
setting
Select the main charge voltage of the drum unit, from 0 to 7.
(default: 4)
A higher setting makes it less dense.
A lower setting makes the print output denser.
Altitude setting
Select the altitude of your location:(default: 0)
0:0 to1500 meters (0 to 4921feet)
1:1500 to 2500 meters(4921 to 8202 feet)
2:2500 to 3500meters (8202 to 11,482.8 feet).
Drum refresh
Select to clean the drum unit if printout appear blurry or has
spots where information is missing.
Adjust print
position
Printing start posi-
tion
Type or select the top and left margin starting position for sin-
gle-sided printing, from -10 to +10 mm.
Type or select the top and left margin starting position for
duplex printing,from -10 to +10 mm.
Each unit of change moves the position by 0.1mm.
Single-sided printing
Adjusts the position of the
printed image.
Duplex printing
Adjusts the position of the
image printed on the back
side of the paper when
duplex printing is used.
Print margins Type or select desired margins of all edges, from 0 to 10 mm.
This setting applies to the FAX and copy functions only, not to
the printing function, where margins are usually set from
within an application.
A higher setting makes the margin wider.
A lower setting makes the margin narrower.
Each unit of change moves the margin by 0.1 mm.
Adjusts the width of the top
edge, bottom edge, left edge
and right edge margins.
*:This setting applies to the
FAX and copy functions only,
not to the printing func-
tion,where margins are usu-
ally set from within an
application.
To Next Page
Loading...
Need help?
General
