Command format: GET●
Response format: pr●
n
Example:
˃ GET /MEDIA/VIDEO/XP.DestinationPortStatus
˂ pr /MEDIA/VIDEO/XP.DestinationPortStatus=M00BF;T00EF
Legend: See at previous section.
M 0 0 B
Unlocked,
Muted
0 0 0 0 0 0 0 0 1 0 1 1 1 1 1 1
Reserved Reserved Reserved Reserved
No embedded
audio
Encrypted
Signal
presents
Connected
Command format: GET●
Response format: pr●
n
Legend:
n
Example:
˃ GET /MEDIA/VIDEO/XP.DestinationConnectionList
˂ pr /MEDIA/VIDEO/XP.DestinationConnectionList=I1
Explanation: I1 input port is connected to the output port.
Switching Video Input
Command format: CALL●
n
m
Response format: mO●
Example:
˃ CALL /MEDIA/VIDEO/XP:switch(I2:O1)
˂ mO /MEDIA/VIDEO/XP:switch
Explanation: I2 port is connected to O1 port.
Command format: GET●
Response format: pr●
n
The response shows the settings of each output one by one.
Legend:
n
Letter Explanation
1
st
letter
E: Autoselect is enabled.
D: Autoselect is disabled.
2
nd
letter
F: First
P: Priority detect mode: always the highest priority active video input will be selected.
L: Last detect mode: always the last attached input is switched to the output automatically.
Example:
˃ GET /MEDIA/VIDEO/XP.DestinationPortAutoselect
˂ pr /MEDIA/VIDEO/XP.DestinationPortAutoselect=EL
Explanation:
EL: the Autoselect is Enabled on output, selected mode is Last detect.
INFO: For more information about the Autoselect feature see The Autoselect Feature section.
Change the Autoselect Mode
Command format: CALL●
n
n
Response format: mO●
Legend: see previous section.
Example1:
˃ CALL /MEDIA/VIDEO/XP:setDestinationPortAutoselect(O1:EPM)
˂ mO /MEDIA/VIDEO/XP:setDestinationPortAutoselect
Explanation1
(P), and the port will be disconnected if a higher priority port becomes active (M).
Example2:
˃ CALL /MEDIA/VIDEO/XP:setDestinationPortAutoselect(O1:D)
˂ mO /MEDIA/VIDEO/XP:setDestinationPortAutoselect
Explanation2
unchanged. Since the outputs are linked, the change will affect local and link out.
To Next Page
Loading...
Need help?
General
