8. Firmware Upgrade HDMI-3D-OPT series – User's Manual 82
perform a factory reset – it means all settings will be erased in the device. For the detailed information about
saved data refer to Content of Backup File section.
The ow chart of the rmware upgrade procedure
The details about the procedure:
package checks the backup data and
if it is needed, a conversion is applied
to avoid incompatibility problems
settings, you can set the Factory reset
option enabled.
package of the device will inform
you about this function availability,
reading it is highly recommended in
every case.
Instructions page in the optical extender rmware package
ATTENTION!
to the device. If a warning message appears, user can get back the original data from the backup. Logs of
the upgrade procedure contain all backup data, it can be exported at the end of the upgrade procedure. In
case of any question, please contact support@lightware.com.
ATTENTION!
details in the Firmware Components section.
ATTENTION! The feature is only supported by LDU version 1.3.0 and above.
Backup
Conversion/RestoreStart
Factory reset End
Upgrading
To Next Page
Loading...
Need help?
General
